CVE-2023-53523

What the bug is

If the gs_usb device driver is unloaded (or unbound) before the interface is shut down, the USB stack first calls the struct usb_driver::disconnect and then the struct net_device_ops::ndo_stop callback. In gs_usb_disconnect() all pending bulk URBs are killed, i.e. no more RX'ed CAN frames are send from the USB device to the host. Later in gs_can_close() a reset control message is send to each CAN channel to remove the controller from the CAN bus. In this race window the USB device can still receive CAN frames from the bus and internally queue them to be send to the host. At least in the current version of the candlelight firmware, the queue of received CAN frames is not emptied during the reset command. After loading (or binding) the gs_usb driver, new URBs are submitted during the struct net_device_ops::ndo_open callback and the candlelight firmware starts sending its already queued CAN frames to the host. However, this scenario was not considered when implementing the hardware timestamp function. The cycle counter/time counter infrastructure is set up (gs_usb_timestamp_init()) after the USBs are submitted, resulting in a NULL pointer dereference if timecounter_cyc2time() (via the call chain: gs_usb_receive_bulk_callback() -> gs_usb_set_timestamp() -> gs_usb_skb_set_timestamp()) is called too early. Move the gs_usb_timestamp_init() function before the URBs are submitted to fix this problem. For a comprehensive solution, we need to consider gs_usb devices with more than 1 channel. The cycle counter/time counter infrastructure is setup per channel, but the RX URBs are per device. Once gs_can_open() of _a_ channel has been called, and URBs have been submitted, the gs_usb_receive_bulk_callback() can be called for _all_ available channels, even for channels that are not running, yet. As cycle counter/time counter has not set up, this will again lead to a NULL pointer dereference. Convert the cycle counter/time counter from a "per channel" to a "per device" functionality. Also set it up, before submitting any URBs to the device. Further in gs_usb_receive_bulk_callback(), don't process any URBs for not started CAN channels, only resubmit the URB.

Where it lives

The fix touches these files. If the subsystem is one you do not use, the practical exposure is lower, though the package is still the vulnerable one.

drivers/net/can/usb/gs_usb.c

What this is

CAN NETWORK DRIVERSMAINTAINERS section matched on drivers/net/can/ · linux-can@vger.kernel.org · Maintained

Kernel module

gs_usb

Check it on the machine

grep -wE 'CONFIG_CAN|CONFIG_CAN_GS_USB' /boot/config-$(uname -r)

Reads the booted kernel's own configuration, on the machine and nowhere else. =y is built in, =m is a module, and an is not set line means the code is not there.

lsmod | grep -w gs_usb

Prints a line if that module is loaded right now, and nothing if it is not. One that is not loaded can still be loaded later by anything that needs it.

Show whether Debian builds this, per release

Debian builds this, but not on every flavour. At least one release below builds the code on some of its kernel flavours and not on others, so the answer depends on the architecture and flavour installed.

• bookworm, trixie, forky, sidMnot built on amd64/cloud-amd64, arm64/cloud-arm64

M

a module where it is built at all; some flavours do not build it

Build switches

CONFIG_CAN, CONFIG_CAN_GS_USB

Reads as

all on means the file is compiled; any one off means it is not.

From the configuration Debian publishes for every kernel flavour it builds. It covers only the architectures Debian ships a linux-config package for, and nothing about a kernel you built yourself. Debian's own status above stays authoritative about the source package.MAINTAINERS kbuild Makefiles Debian linux-config packages

Signals

Published

2025-10-01 (13 months ago)source

CVSS

no vector published, unrated

Attack vector

not published

EPSS

0.13%, higher than 2.1% of all CVEssource

CISA KEV

not listedthe KEV catalogue

Debian urgency

not yet assignedsource

Subsystem

drivers/net

Upstream fixes

The versions the CNA records as introducing and fixing this, and the commit for each. source

Introduced	Fixed in	Commit
6.1	6.4.7	210a8cffc9c1
6.1	6.5	5886e4d5ecec